Phanirithvij: fix orangepi homepage

2024-09-14T09:40:50Z

fix orangepi homepage

← Older revision		Revision as of 09:40, 14 September 2024
Line 64:		Line 64:
	== Resources ==		== Resources ==

	* [http://www.orangepi.org~~/orangepipc~~/ Official product page]		* [http://www.orangepi.org/ Official product page]
	* [https://linux-sunxi.org/Xunlong_Orange_Pi_PC linux-sunxi wiki page]		* [https://linux-sunxi.org/Xunlong_Orange_Pi_PC linux-sunxi wiki page]

imported>Samueldr: Add note about content being out-of-date

2021-12-26T22:17:20Z

Add note about content being out-of-date

← Older revision		Revision as of 22:17, 26 December 2021
Line 26:		Line 26:

	== Status ==		== Status ==

			{{outdated\|Section refers to old user-provided images. Should be reviewed with cross-compilation, or native compilation through userspace emulation.}}

	'''@dezgeg''''s porting efforts to ARMv7 works on the Orange Pi One, using the proper upstream u-boot.		'''@dezgeg''''s porting efforts to ARMv7 works on the Orange Pi One, using the proper upstream u-boot.

imported>Makefu: init

2019-03-08T09:04:17Z

init

New page

{{ARM/breadcrumb}}
<div class="infobox">
{|class="table"
!colspan="2" class="title"|Orange Pi One
|-
|colspan="2"|[[File:orange_pi_one.jpg|frameless|256px|Orange Pi One.]]
|-
!Manufacturer
|Xunlong / Orange Pi
|-
!Architecture
|ARMv7
|-
!Bootloader
|Upstream u-boot
|-
!Maintainer
|[[User:makefu|makefu]]
|-
!URL
|[http://linux-sunxi.org/Xunlong_Orange_Pi_One_%26_Lite Sunxi Wiki]
|}
</div>

The Orange Pi One is an Xunlong SoC based on the Allwinner H3. As the board is on the market for quite some time and the device is relatively cheap, the community effort resulted in a better than average mainline support with the current kernel (5.0). Refer to the H3 column in the [http://linux-sunxi.org/Mainlining_Effort#Status_Matrix SunXI Mainline Status Matrix].

== Status ==

'''@dezgeg''''s porting efforts to ARMv7 works on the Orange Pi One, using the proper upstream u-boot.

Even though the upstream uboot does support the Orange Pi One, it is not part of nixpkgs. However with the new cross-compiler toolchain added with nixpkgs-18.09 it is straight forward to build the bootloader yourself.

== Board-specific installation notes ==

First follow the [[NixOS_on_ARM#Installation|generic installation steps]] to get the installer image on an SD card.

U-Boot needs to be copied to specific sectors on the microSD card with <code>dd</code>. At first, build the u-boot for the device, then copy it to the correct location with (again, replace <code>/dev/sdX</code> with the correct path to the SD card device):

<syntaxhighlight lang="bash">
nix-build -E 'let plat = ((import <nixpkgs> ){}).pkgsCross.armv7l-hf-multiplatform; in plat.buildUBoot{defconfig = "orangepi_one_defconfig"; extraMeta.platforms = ["armv7l-linux"]; filesToInstall = ["u-boot-sunxi-with-spl.bin"];}'
sudo dd if=result/uboot-orangepi_pc_defconfig-2017.11.nixpkgs.*.u-boot-sunxi-with-spl.bin of=/dev/sdX bs=1024 seek=8
</syntaxhighlight>

Then, install using the [[NixOS_on_ARM#NixOS_installation_.26_configuration|installation and configuration steps]].

== Serial console==

Your configuration.nix will need to add <code>console=ttyS0,115200n8</code> to the <code>boot.kernelParams</code> configuration to use the serial console.

{{file|/etc/nixos/configuration.nix|nix|<nowiki>
{ config, pkgs, lib, ... }:
{
boot.kernelParams = [
"console=ttyS0,115200n8"
];
}
</nowiki>}}
== Compatibility notes ==

* Ethernet works with 4.19 kernel
* HDMI should work since kernel 4.17 (untested)
== Resources ==

* [http://www.orangepi.org/orangepipc/ Official product page]
* [https://linux-sunxi.org/Xunlong_Orange_Pi_PC linux-sunxi wiki page]

NixOS on ARM/Orange Pi One - Revision history

Phanirithvij: fix orangepi homepage

imported>Samueldr: Add note about content being out-of-date

imported>Makefu: init