NixOS on ARM/PcDuino3 Nano - Revision history

imported>Samueldr: Add note about content being out-of-date

2021-12-26T22:17:00Z

Add note about content being out-of-date

← Older revision		Revision as of 22:17, 26 December 2021
Line 10:		Line 10:
	<!-- TODO : write intro paragraph -->		<!-- TODO : write intro paragraph -->
	== Status ==		== Status ==

			{{outdated\|Section refers to old user-provided images. Should be reviewed with cross-compilation, or native compilation through userspace emulation.}}

	'''@dezgeg''''s porting efforts to ARMv7 should work.		'''@dezgeg''''s porting efforts to ARMv7 should work.

imported>Samueldr: Adds breadcrumb

2017-12-17T22:58:13Z

Adds breadcrumb

← Older revision		Revision as of 22:58, 17 December 2017
Line 1:		Line 1:
			{{ARM/breadcrumb}}
	<div class="infobox">		<div class="infobox">
	{\|class="table"		{\|class="table"

imported>Samueldr: Imports contents in page.

2017-12-17T21:39:10Z

Imports contents in page.

New page

<div class="infobox">
{|class="table"
!colspan="2" class="title"|pcDuino3 Nano
|-
!Architecture
|ARMv7
|}
</div>

== Status ==

'''@dezgeg''''s porting efforts to ARMv7 should work.

== Board-specific installation notes ==

First follow the [[NixOS_on_ARM#Installation|generic installation steps]] to get the installer image.

U-Boot needs to be copied to specific sectors on the microSD card with dd. Download U-Boot for the board (<code>uboot-Linksprite_pcDuino3_Nano_defconfig-2015.07_u-boot-sunxi-with-spl.bin</code>), and copy it to the correct location with (again, replace <code>/dev/sdX</code> with the correct path to the SD card device):

<syntaxhighlight lang="bash">sudo dd if=uboot-Linksprite_pcDuino3_Nano_defconfig-2015.07_u-boot-sunxi-with-spl.bin of=/dev/sdX bs=1024 seek=8</syntaxhighlight>

Then, install using the [[NixOS_on_ARM#NixOS_installation_.26_configuration|installation and configuration steps]].

== Serial console==

{{expansion|The exact <code>console</code> parameter is needed.}}

== Notes about the boot process ==

USB keyboards and HDMI displays work perfectly. Also a 3.3v serial port via the 3-pin header works.