Btrfs: Difference between revisions

From NixOS Wiki
imported>Vixea
Undo revision 8153 by Vixea (talk) sadly it doesn't solve the issue builds but leaves system un bootable
imported>Vixea
Undo revision 8152 by Vixea (talk)
Line 30: Line 30:
# mount -o compress=zstd,noatime,subvol=nix /dev/sdX2 /mnt/nix
# mount -o compress=zstd,noatime,subvol=nix /dev/sdX2 /mnt/nix


# mkdir /mnt/@/boot
# mkdir /mnt/boot
# mount /dev/sdX1 /mnt/@/boot
# mount /dev/sdX1 /mnt/boot
</syntaxhighlight>
</syntaxhighlight>



Revision as of 06:07, 3 September 2022

btrfs is a modern copy on write (CoW) filesystem for Linux aimed at implementing advanced features while also focusing on fault tolerance, repair and easy administration.

Installing NixOS on Btrfs

Note: The following example is for EFI enabled systems. Adjust commands accordingly for a BIOS installation.

Partition the disk

# printf "label: gpt\n,550M,U\n,,L\n" | sfdisk /dev/sdX

Format partitions and create subvolumes

# mkfs.fat -F 32 /dev/sdX1

# mkfs.btrfs /dev/sdX2
# mkdir -p /mnt
# mount /dev/sdX2 /mnt
# btrfs subvolume create /mnt/root
# btrfs subvolume create /mnt/home
# btrfs subvolume create /mnt/nix
# umount /mnt

Mount the partitions and subvolumes

# mount -o compress=zstd,subvol=root /dev/sdX2 /mnt
# mkdir /mnt/{home,nix}
# mount -o compress=zstd,subvol=home /dev/sdX2 /mnt/home
# mount -o compress=zstd,noatime,subvol=nix /dev/sdX2 /mnt/nix

# mkdir /mnt/boot
# mount /dev/sdX1 /mnt/boot

Install NixOS

# nixos-generate-config --root /mnt/@
# nano /mnt/etc/nixos/configuration.nix # manually add mount options
# nixos-install

Compression

nixos-generate-config --show-hardware-config --root /mnt/@ doesn't detect mount options automatically, so to enable compression, you must specify it and other mount options in a persistent configuration:

fileSystems = {
  "/".options = [ "compress=zstd" ];
  "/home".options = [ "compress=zstd" ];
  "/nix".options = [ "compress=zstd" "noatime" ];
  "/swap".options = [ "noatime" ];
};

Swap file

Optionally, create a separate subvolume for the swap file. Be sure to regenerate your hardware-configuration.nix if you choose to do this.

# mkdir -p /mnt
# mount /dev/sdXY /mnt
# btrfs subvolume create /mnt/swap
# umount /mnt
# mkdir /swap
# mount -o subvol=swap /dev/sdXY /swap

Then, create the swap file with copy-on-write and compression disabled:

# truncate -s 0 /swap/swapfile
# chattr +C /swap/swapfile
# btrfs property set /swap/swapfile compression none
# dd if=/dev/zero of=/swap/swapfile bs=1M count=4096
# chmod 0600 /swap/swapfile
# mkswap /swap/swapfile

Finally, add the swap file to your configuration and nixos-rebuild switch:

swapDevices = [ { device = "/swap/swapfile"; } ];