NixOS on ARM/Wandboard: Difference between revisions
imported>Samueldr m Adds breadcrumb |
imported>Samueldr Add note about content being out-of-date |
||
| Line 12: | Line 12: | ||
<!-- TODO : write intro paragraph --> | <!-- TODO : write intro paragraph --> | ||
== Status == | == Status == | ||
{{outdated|Section refers to old user-provided images. Should be reviewed with cross-compilation, or native compilation through userspace emulation.}} | |||
'''@dezgeg''''s porting efforts to ARMv7 should work. | '''@dezgeg''''s porting efforts to ARMv7 should work. | ||
Latest revision as of 22:17, 26 December 2021
| Wandboard Family | |
|---|---|
| Solo/Dual/Quad | |
| Architecture | ARMv7 |
Status
⏲︎︎
This article or section is outdated. Section refers to old user-provided images. Should be reviewed with cross-compilation, or native compilation through userspace emulation. Further information might be found in the corresponding discussion. Please remove this notice once the information has been updated.
@dezgeg's porting efforts to ARMv7 should work.
Board-specific installation notes
First follow the generic installation steps to get the installer image.
U-Boot and its SPL need to be copied to specific sectors on the microSD card with dd. Download U-Boot & SPL for the board (uboot-wandboard_defconfig-2017.03_u-boot.img, uboot-wandboard_defconfig-2017.03_SPL), and copy them to the correct location with (again, replace /dev/sdX with the correct path to the SD card device):
sudo dd if=uboot-wandboard_defconfig-2017.03_SPL of=/dev/sdX seek=1 bs=1k
sudo dd if=uboot-wandboard_defconfig-2017.03_u-boot.img of=/dev/sdX seek=69 bs=1k
Note: Only the Quad model has been tested, but the others should work as well with the same U-Boot binary.
Then, install using the installation and configuration steps.
Serial console
☶︎
This article or section needs to be expanded. Further information may be found in the related discussion page. Please consult the pedia article metapage for guidelines on contributing.
Notes about the boot process
Only serial console (via the DB-9 connector) is supported.