NixOS on ARM/Orange Pi PC: Difference between revisions
imported>Samueldr Add note about content being out-of-date |
Phanirithvij (talk | contribs) m fix orangepi homepage |
||
| (One intermediate revision by one other user not shown) | |||
| Line 14: | Line 14: | ||
|- | |- | ||
!Maintainer | !Maintainer | ||
| | | | ||
|} | |} | ||
</div> | </div> | ||
| Line 57: | Line 57: | ||
== Resources == | == Resources == | ||
* [http://www.orangepi.org | * [http://www.orangepi.org Official product page] | ||
* [https://linux-sunxi.org/Xunlong_Orange_Pi_PC linux-sunxi wiki page] | * [https://linux-sunxi.org/Xunlong_Orange_Pi_PC linux-sunxi wiki page] | ||
Latest revision as of 09:40, 14 September 2024
| Orange Pi PC | |
|---|---|
| Manufacturer | Xunlong / Orange Pi |
| Architecture | ARMv7 |
| Bootloader | Upstream u-boot |
| Maintainer | |
Status
 |
This article or section is out of date.
Reason: Section refers to old user-provided images. Should be reviewed with cross-compilation, or native compilation through userspace emulation. (Discuss in Talk:NixOS on ARM/Orange Pi PC)
Once the page has been updated this notice can be removed. |
@dezgeg's porting efforts to ARMv7 works on the Orange Pi PC, using the proper upstream u-boot.
U-boot support has been merged 2017-12-11.
Board-specific installation notes
First follow the generic installation steps to get the installer image on an SD card.
U-Boot needs to be copied to specific sectors on the microSD card with dd. Download u-boot for the board (uboot-orangepi_pc_defconfig-2017.11.nixpkgs.*.u-boot-sunxi-with-spl.bin), and copy it to the correct location with (again, replace /dev/sdX with the correct path to the SD card device):
sudo dd if=uboot-orangepi_pc_defconfig-2017.11.nixpkgs.*.u-boot-sunxi-with-spl.bin of=/dev/sdX bs=1024 seek=8
Then, install using the installation and configuration steps.
Serial console
Your configuration.nix will need to add console=ttyS0,115200n8 to the boot.kernelParams configuration to use the serial console.
/etc/nixos/configuration.nix
{ config, pkgs, lib, ... }:
{
boot.kernelParams = [
"console=ttyS0,115200n8"
];
}
Compatibility notes
- Using the upstream kernel at 4.13, neither HDMI nor Ethernet will work.
- #29569 has a comment with a compatible linux kernel overlay derivation.
- Support for ethernet may land in 4.15.
- HDMI support isn't in the maintainer's requirements, it may start working in the future.