NixOS on ARM/Kosagi Novena: Difference between revisions
No edit summary |
m Samueldr moved page NixOS on ARM/Novena to NixOS on ARM/Kosagi Novena |
||
| (6 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
We now have https://github.com/novena-next/nixos-novena repository that can be used to build Novena specific kernel and few other tools like | {{ARM/breadcrumb}} | ||
We now have https://github.com/novena-next/nixos-novena repository that can be used to build Novena specific kernel and few other tools like <code>novena-eeprom</code> and <code>novena-usb-hub</code>. | |||
Also check out https://github.com/novena-next/docs for general purpose documentation. This guide might move there at some point. | Also check out https://github.com/novena-next/docs for general purpose documentation. This guide might move there at some point. | ||
| Line 13: | Line 14: | ||
Build u-boot according to | Build u-boot according to | ||
[[NixOS_on_ARM#Building_u-boot_from_your_NixOS_PC]] | |||
{{commands|<nowiki> | {{commands|<nowiki> | ||
| Line 26: | Line 27: | ||
Proceed with standard installation steps and | Proceed with standard installation steps and | ||
[[NixOS_on_ARM#Building_U-Boot_from_your_NixOS_PC]] | |||
You can use your own layout when installing on the hard drive (SD-card is still needed to boot from SATA), <code>extlinux</code> insted of <code>grub</code> is important. | You can use your own layout when installing on the hard drive (SD-card is still needed to boot from SATA), <code>extlinux</code> insted of <code>grub</code> is important. | ||
| Line 42: | Line 43: | ||
reset | reset | ||
</nowiki>}} | </nowiki>}} | ||
Latest revision as of 03:06, 5 April 2024
We now have https://github.com/novena-next/nixos-novena repository that can be used to build Novena specific kernel and few other tools like novena-eeprom and novena-usb-hub.
Also check out https://github.com/novena-next/docs for general purpose documentation. This guide might move there at some point.
Using generic image
use generic armv7l image (sd-image-armv7l-linux.img)
U-boot
Build u-boot according to
NixOS_on_ARM#Building_u-boot_from_your_NixOS_PC
make novena_defconfig
dd if=SPL of=/dev/sdc seek=1 bs=1k
Store u-boot.bin on /boot (mounted sd-image).
Proceed with standard installation steps and NixOS_on_ARM#Building_U-Boot_from_your_NixOS_PC
You can use your own layout when installing on the hard drive (SD-card is still needed to boot from SATA), extlinux insted of grub is important.
Configuring SATA boot
To enable booting from SATA by default enable sataroot feature with novena-eeprom and then break to u-boot shell and run following commands to set different boot order:
TODO: disk ID
printenv setenv boot_targets sata0 saveenv reset