NixOS on ARM/PcDuino3 Nano: Difference between revisions
imported>Samueldr Imports contents in page. |
imported>Samueldr m Adds breadcrumb |
||
| Line 1: | Line 1: | ||
{{ARM/breadcrumb}} | |||
<div class="infobox"> | <div class="infobox"> | ||
{|class="table" | {|class="table" | ||
Revision as of 22:58, 17 December 2017
| pcDuino3 Nano | |
|---|---|
| Architecture | ARMv7 |
Status
@dezgeg's porting efforts to ARMv7 should work.
Board-specific installation notes
First follow the generic installation steps to get the installer image.
U-Boot needs to be copied to specific sectors on the microSD card with dd. Download U-Boot for the board (uboot-Linksprite_pcDuino3_Nano_defconfig-2015.07_u-boot-sunxi-with-spl.bin), and copy it to the correct location with (again, replace /dev/sdX with the correct path to the SD card device):
sudo dd if=uboot-Linksprite_pcDuino3_Nano_defconfig-2015.07_u-boot-sunxi-with-spl.bin of=/dev/sdX bs=1024 seek=8
Then, install using the installation and configuration steps.
Serial console
 |
This article or section needs expansion.
Reason: The exact
console parameter is needed. (Discuss in Talk:NixOS on ARM/PcDuino3 Nano#)Please consult the pedia article metapage for guidelines on contributing. |
Notes about the boot process
USB keyboards and HDMI displays work perfectly. Also a 3.3v serial port via the 3-pin header works.