NixOS on ARM/PcDuino3 Nano: Difference between revisions
imported>Samueldr Imports contents in page. |
imported>Samueldr m Adds breadcrumb |
||
| Line 1: | Line 1: | ||
{{ARM/breadcrumb}} | |||
<div class="infobox"> | <div class="infobox"> | ||
{|class="table" | {|class="table" | ||
Revision as of 22:58, 17 December 2017
| pcDuino3 Nano | |
|---|---|
| Architecture | ARMv7 |
Status
@dezgeg's porting efforts to ARMv7 should work.
Board-specific installation notes
First follow the generic installation steps to get the installer image.
U-Boot needs to be copied to specific sectors on the microSD card with dd. Download U-Boot for the board (uboot-Linksprite_pcDuino3_Nano_defconfig-2015.07_u-boot-sunxi-with-spl.bin), and copy it to the correct location with (again, replace /dev/sdX with the correct path to the SD card device):
sudo dd if=uboot-Linksprite_pcDuino3_Nano_defconfig-2015.07_u-boot-sunxi-with-spl.bin of=/dev/sdX bs=1024 seek=8
Then, install using the installation and configuration steps.
Serial console
☶︎
This article or section needs to be expanded. Further information may be found in the related discussion page. Please consult the pedia article metapage for guidelines on contributing.
Notes about the boot process
USB keyboards and HDMI displays work perfectly. Also a 3.3v serial port via the 3-pin header works.