Talk:NixOS on ARM/PINE64 ROCKPro64

Note: It is not recommended to connect the serial adapter to pin 10 (RX) while booting, as this often causes the board to hang early in the bootloader. Disconnecting pin 10 still allows the serial console to be viewed, and it can be reconnected after the board boots, allowing interaction with the console.

Was this observed using the Pine64 USB Serial Console? I have a different make of USB-serial adaptor and haven't noticed any such issues. Is it possible this is a quirk of a specific serial adaptor rather than an issue with the RockPro64 itself? (Or maybe it's been fixed in u-boot or something?) Thra11 (talk) 12:32, 22 August 2019 (UTC)