NixOS on ARM/Wandboard: Difference between revisions
imported>Samueldr m Adds breadcrumb |
imported>Samueldr Add note about content being out-of-date |
||
| Line 12: | Line 12: | ||
<!-- TODO : write intro paragraph --> | <!-- TODO : write intro paragraph --> | ||
== Status == | == Status == | ||
{{outdated|Section refers to old user-provided images. Should be reviewed with cross-compilation, or native compilation through userspace emulation.}} | |||
'''@dezgeg''''s porting efforts to ARMv7 should work. | '''@dezgeg''''s porting efforts to ARMv7 should work. | ||
Latest revision as of 22:17, 26 December 2021
| Wandboard Family | |
|---|---|
| Solo/Dual/Quad | |
| Architecture | ARMv7 |
Status
 |
This article or section is out of date.
Reason: Section refers to old user-provided images. Should be reviewed with cross-compilation, or native compilation through userspace emulation. (Discuss in Talk:NixOS on ARM/Wandboard)
Once the page has been updated this notice can be removed. |
@dezgeg's porting efforts to ARMv7 should work.
Board-specific installation notes
First follow the generic installation steps to get the installer image.
U-Boot and its SPL need to be copied to specific sectors on the microSD card with dd. Download U-Boot & SPL for the board (uboot-wandboard_defconfig-2017.03_u-boot.img, uboot-wandboard_defconfig-2017.03_SPL), and copy them to the correct location with (again, replace /dev/sdX with the correct path to the SD card device):
sudo dd if=uboot-wandboard_defconfig-2017.03_SPL of=/dev/sdX seek=1 bs=1k
sudo dd if=uboot-wandboard_defconfig-2017.03_u-boot.img of=/dev/sdX seek=69 bs=1k
Then, install using the installation and configuration steps.
Serial console
 |
This article or section needs expansion.
Reason: The exact
console parameter is needed. (Discuss in Talk:NixOS on ARM/Wandboard#)Please consult the pedia article metapage for guidelines on contributing. |
Notes about the boot process
Only serial console (via the DB-9 connector) is supported.